Removal and Installation

REMOVAL
1. Remove the fluid level warning device connector.
2. Detach the brake tubes from the master cylinder, and then install the plug.

CAUTION: Painted on the surface, wash it off immediately. if there is brake fluid.





3. Remove master cylinder mounting nuts and then lift out the master cylinder.

INSTALLATION
1. Install the master cylinder to the brake booster.
2. Install the booster and master cylinder to the dash panel.
3. Connect the brake tubes to the master cylinder.
4. Install the vacuum hose tightly.
5. Connect the operating rod to the brake pedal.
6. After filling the brake reservoir with the brake fluid, bleed the system.

CAUTION: Don't disassemble the brake booster.