C - For Tiburon Vehicles Equipped With ABS

CAUTION:
Wear eye protection when performing this procedure:

1. Verify the vehicle is affected by identifying the vehicle production date range and VIN.





NOTE:
Apply this procedure to both left and right sides at the rear brake tube contact areas with the steering gear box mounting brackets.

2. Raise the vehicle.





3. Locate the rear brake tube contact areas with the steering gear box mounting brackets.

4. Clean the contact areas using shop air and a rag.





5. Prepare the brake tube clip as shown.





6. Make a gap between the rear brake tube and the steering gear box mounting bracket by gently prying with a flathead screwdriver.

7. Install the brake tube clip on the rear brake tubes where the tubes contact the steering gear box mounting bracket.





NOTE:
The brake tube clip is directional. The locking tabs inside the clip should face toward the vehicle front.





8. Install the rear brake tube clip on the other side of the vehicle on the rear brake tubes at the contact area with the steering gear box mounting bracket.

9. Lower the vehicle.