D - For Tiburon Vehiclles Not Equipped With ABS

CAUTION:
Wear eye protection when performing this procedure:

1. Verify the vehicle is affected by identifying the vehicle production date range and VIN.





NOTE:
Apply this procedure to left side at the rear brake tube contact area with the steering gear box mounting bracket.

2. Raise the vehicle.

3. Locate the rear brake tube contact area with the steering gear box mounting bracket.





4. Clean the contact area using shop air and a rag.





5. Prepare the brake tube clip as shown.





6. Make a gap between the rear brake tubes and the steering gear box mounting bracket by gently prying with a flathead screwdriver.





7. Install the brake tube clip on the rear brake tubes where the tube contacts the steering gear box mounting bracket.








NOTE:
The brake tube clip is directional. The locking tabs inside the clip should face toward the vehicle front.

8. Lower the vehicle.