Interior - Door Trim Panel Scratch Repair Procedure
Group: BODYNumber: 09-BD-005
Date: MARCH, 2009
Model:
2007 3-DOOR ACCENT
Subject:
DOOR TRIM PANEL SCRATCH REPAIR
DESCRIPTION:
Some 2007 3-door Accent (MC) door trim panels may exhibit light scratches or marring. This bulletin describes the procedure to repair light scratches and increase the durability of the surface.
NOTE:
This TSB does not apply to deep scratches or gouges.
APPLICABILITY:
^ 3-door Accent (MC) vehicles produced from Job #1 through August 27, 2007.
SERVICE PROCEDURE:
1. Remove the door trim panel screws (5) and the side rear view mirror's inner cover.
2. Remove the door trim panel by pulling upwards. Disconnect the wiring harness connectors from the door trim panel.
3. Remove the tweeter speaker from the door trim panel and secure the door trim panel vertically. Wipe with Parakleen solution using a clean, lint free towel.
4. Using masking tape, mask off the switch assembly and inner beltline moulding area (upper edge of door panel).
5. Shake the can of Plastikprep adhesion promoter vigorously and spray one light coat approximately 6 to 8 inches from the surface. Let dry for 2 to 5 minutes.
IMPORTANT:
Use only in a well ventilated area.
6. Shake the can of Varibond vigorously and apply 2 to 3 light coats approximately 6 to 8 inches from the surface of the door trim panel. Allow 5 to 10 minutes between coats for drying.
IMPORTANT:
Do not apply a thick coat as this will prevent proper curing of the product.
7. Wait approximately 45 minutes for the panel to dry and reinstall in the reverse order of removal.
8. Apply Plastic Care sealer/protector to the door trim panel surface using a clean towel or foam pad.
PART INFORMATION
WARRANTY INFORMATION