Rear Wiper Motor
REAR WIPER MOTORREM0VAL
1. Remove the tail gate trim.
2. Detach the wiper cap (A), and then remove the rear wiper arm after removing a nut (B).
Tightening torque Nut (B): 10-13 N.m (1.0-1.3 kgf.m, 7.2-9.4 lbf.ft)
3. Detach the wiper motor cover, and then remove the rear wiper cap & pad (B) after removing a nut (A).
NOTE: When installing the rear wiper cap & pad, in order for the arrow mark toward an upper direction.
Tightening torque Nut (A): 10-13 N.m (1.0-1.3 kgf.m, 7.2-9.4 lbf.ft)
4. Disconnect the rear wiper motor connector (B) then remove the rear wiper motor (A) after removing 2 bolts.
Tightening torque Nut: 7-11 N.m (0.7-1.1 kgf.m, 5.1-8.0 lbf.ft)
5. Installation is the reverse of removal.
INSTALLATION
1. Install the rear wiper arm and blade to the specified position.
2. Set the rear washer nozzle on the specified spray position.