C2370

DTC C2366 TCS VALVE PRIMARY (USV1) ERROR
DTC C2370 TCS VALVE SECONDARY (USV2) ERROR
DTC C2372 ESC VALVE 1 (HSV1) ERROR
DTC C2374 ESC VALVE 2 (HSV2) ERROR

COMPONENT LOCATION
Refer to DTC C1235. C1235

GENERAL DESCRIPTION
Refer to DTC C2308. C2308

DTC DESCRIPTION
Refer to DTC C2308. C2308

DTC DETECTING CONDITION:

MONITOR ACTUATION TEST
1. Connect Scantool to Data Link Connector (DLC)
2. Ignition "ON" & Engine "OFF".
3. Select the "Actuation Test" mode on the Scantool.
4. Inspect operating status of inlet valve with Actuation Test.





5. Does a inlet valve operate normally?
YES
> Fault is intermittent caused by inoperative valve or was repaired and HECU memory was not cleared. Go to the applicable troubleshooting procedure.
NO
> Go to "W/Harness Inspection" procedure.

TERMINAL AND CONNECTOR INSPECTION
Refer to DTC C2308. C2308

VERIFICATION OF VEHICLE REPAIR
Refer to DTC C2308. C2308