Installation

FRONT STABILIZER BAR

INSTALLATION





1. Install the bushing (B) on the stabilizer bar (A).

NOTE
Bring clamp (C) of stabilizer bar (A) into contact with bushing (B).

2. Install the bracket on the bushing (B).
3. After tightening the bolts of the bushing bracket temporarily, install the bushing bracket on the opposite side.

Tightening torque
45-55 Nm (4.5-5.5 kgf-m, 32-39 lb-ft)

4. Install the six subframe mounting bolts, then the two engine mounting bolts (A, B).








5. Install the connecting bolt (A) between the steering universal joint assembly and the pinion assembly





6. Install the pressure pipe mounting bolt (A).





7. Connect between the return tube and hose (A).





CAUTION
Be sure to connect between a tube and a hose as shown in the illustration.





8. Install the two bolts (A) for the lower arm ball joint.





9. Install the nut (B) on the stabilizer bar link (A).





10. Install the tie rod end on the knuckle.
11. Install the front wheel and tire (A) on the front hub (B).





CAUTION
Be careful not to do damage the hub bolts (C) then install the front wheel and tire (A).

12. Refill the power steering fluid (PSF-3).

CAUTION
After installation, bleed the air in the power steering system.