Verification of Vehicle Repair

Brake

ABS/ESC - C1211 Wheel Speed Sensor Rear-RH Invalid/no Signal - Verification of Vehicle Repair

Verification of Vehicle Repair

After a repair, it is essential to verify that the fault has been corrected.
1. Connect scantool and select "Diagnostic Trouble Codes (DTCs)" mode
2. Using a scantool, Clear DTC.
3. Operate the vehicle within DTC Detecting Condition in General Information. (Start and drive vehicle in gear and maintain vehicle speed at or above 50 kmh. (31 mph)
4. Are any DTCs present?