A/T - Fluid Level Checking Procedure

Group: AUTOMATIC TRANSAXLE

Number: 09-AT-001

Date: JANUARY, 2009

Model: 2010- GENESIS COUPE V6, 2009- GENESIS V8

Subject:
GENESIS COUPE V6 AND GENESIS V8 AUTOMATIC TRANSMISSION FLUID LEVEL

This TSB revises 08-AT-008 to add Genesis Coupe V6 information

DESCRIPTION:

The Genesis V8 and Genesis Coupe V6 ATF level can be checked by the following
procedure:

NOTE: The Genesis V8 and Genesis Coupe V6 use synthetic automatic transaxle fluid (ATF). Use only ATF meeting the M-1375.4 specification approved by Hyundai Motor Company. DO NOT use SPIII or other ATF which may result in degradation of shift quality or transaxle durability.

ATF LEVEL INSPECTION:





1. Attach a GDS and select Genesis V8 or Genesis Coupe V6 and "A/T" menu.





2. Select Current Data and "Transmission Fluid Temperature Sensor".

3. Drive the vehicle until the fluid temperature is between 86-95°F (30-35°C).





4. Firmly apply the brake and then shift into "R", "N" and "D" and back, pausing 3-5 seconds in each range. Shift into Sports Mode 1 & 2. Repeat two times.

5. Move the shift lever to P, leave the engine running and lift the vehicle on a hoist.





6. Remove the fill plug. The oil level is correct if ATF flows out in a thin oil stream or steady drop-by-drop. If no oil flow occurs, go to Step 7.

NOTE: Collect and dispose of any excess fluid in accordance with local regulations.

7. Add ATF in 1/4 quart increments until ATF flows out of the fill plug in a thin oil stream or steady drop-by-drop.





NOTE: Use a fluid transfer pump to add ATF (Use the following products or equivalent).

^ MAC Tools Fluid Dispenser #MV7201 or #GS19HD

^ Snap-on Suction Gun #YA745ADO NOT use SPIII or other ATF.

8. Reinstall the fill plug and tighten to specification of 20-25 lb-ft (2.8-3.5 kgf.m).





PARTS INFORMATION:





MAINTENANCE SCHEDULE: