Repair Procedures

Removal

1. Disconnect (-) terminal from the battery in order to prevent current from flowing through wire.




2. Remove the shift lever knob by rotating counter clockwise.




3. Remove the indicator assembly.




4. Remove the shift cable assembly (C) by pulling out the snap pin (A) and the socket (B).

NOTE:
Remove the cable upward by pulling the marking part of the socket (B) with thumb.




5. Disconnect the sports mode switch connector.




6. Remove the shift lever assembly by removing bolts(4ea).




7. Remove the retainer by removing nuts(2ea) on the floor.




8. After removing the shift cable assembly from the transmission, pull the shift cable assembly inside the vehicle.

NOTE:
In case of replacing the shift cable assembly, do this procedure.

Inspection

1. Check the shift cable assembly for proper operation and for damage.
2. Check the shift lever assembly for proper operation and for damage.

Adjustment

How To Adjust Shift Cable
1. Insert the shift cable to the bracket and hold it with a new clip.
2. Align the manual lever hole to the hole on the transmission case and hold the position with a bar.
3. Eliminate shift cable free play of the shift cable.
4. Firmly hold the special bolt (A) with a spanner and tighten the nut (B) with the specified torque.

Tightening torque :
13 - 16 Nm(1.3 - 1.6 kgf.m, 9.40 - 11.57 lb-ft)




5. Take off the bar holding the manual lever.
6. Shifting the each position, check that the shift lever moves smoothly.

Installation

1. After inserting the shift cable assembly inside the vehicle. install the shift cable assembly to the transmission,

NOTE:
In case of replacing the shift cable assembly, do this procedure.

2. Install the retainer by installing nuts(2ea) on the floor.




3. Install the shift lever assembly by installing bolts(4ea).




4. Connect the sports mode switch connector.




5. Install the shift cable assembly (C) by inserting the snap pin (A) and the socket (B).




6. Install the indicator assembly.




7. Install the shift lever knob by rotating clockwise.




8. Connect (-) terminal to the battery.