Repair Procedures

Replacement

Sunvisor Replacement

NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Put on gloves to protect your hands.

1. After loosening the mounting screws, then remove the sunvisor (A) and retainer (B).




2. Installation is the reverse of removal.

Assist Handle Replacement

NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Put on gloves to protect your hands.

1. Remove the covers (B)
2. After loosening the mounting bolts, then remove the assist handle (A).




3. Installation is the reverse of removal.

Overhead Console Replacement

NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Put on gloves to protect your hands.

1. After loosening the mounting screws, then remove the overhead console assembly (A).




2. Disconnect the connectors (A).




3. Installation is the reverse of removal.

NOTE:
- Make sure the connector is connected properly.

Roof Trim Replacement

NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
- Put on gloves to protect your hands.

1. Remove the following items.
A. Front seat

B. Rear seat

C. Sunvisor
D. Overhead console
E. Assist handle
F. Front pillar trim

G. Front door scuff trim & Rear door scuff trim

H. Center pillar lower trim & Center pillar upper trim

I. Rear pillar trim

J. Rear wheelhousing trim

K. Floor console

2. Remove the ECM mirror cover (A).
3. Disconnect the ECM mirror connector (B).




4. Disconnect the connectors (A) and then mounting clips in front pillar.

[ Driver's ]





[ Passenger's ]




5. Remove the clips and roof trim (A).




6. Installation is the reverse of removal.

NOTE:
- Replace any damage clips.