Front Seat Belt

Replacement

Front Seat Belt Replacement

CAUTION:
- When installing the belt, make sure not to damaged the pretensioner.

1. Remove the following items first.
A. Front seat assembly
.
B. Front door scuff trim and rear door scuff trim
.
2. Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
3. The seat belt anchor pretensioner (A) be removed after pushing the lock pin (B) as arrow direction.




4. Using a screwdriver or remover, remove the center pillar lower trim (A).




5. After loosening the mounting bolt, then remove the center pillar upper trim (A).




6. Loosen the mounting bolt, then remove the front seat belt upper anchor (A).

Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb-ft)




7. After disconnecting the pretensioner connector lock pin, remove the BPT connector (A), Loosening the mounting bolt, then remove the pretensioner (B).

Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb-ft)




8. Installation is the reverse of removal.

Height Adjuster Replacement
1. Remove the following items first:
A. Front door scuff trim and rear door scuff trim
.
B. Front seat belt lower anchor.
C. Center pillar lower trim.
.
D. Center pillar upper trim
.
E. Front seat belt upper anchor.
2. After loosening the bolts, then remove the height adjustor (A).

Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb-ft)




3. Installation is the reverse of removal.

NOTE:
- Replace any damaged clips.
- Make sure the height adjust properly.

Front Seat Belt Buckle Replacement
1. Remove the following items first:
A. Front seat assembly
.
2. After loosening the mounting screws, then remove the front seat track side cover (A).




3. Disconnect the connect (A) mounting clip.




4. After loosening the mounting bolt, then remove the front seat belt buckle (A).

Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb-ft)




5. Installation is the reverse of removal.