General Information

Cluster Module
B100051 EOL Not Programmed - General Information

Component Location





General Description

Cluster memorizes what kinds of control unit are installed on through the CAN-BUS. Vehicle Optional information is memorized in cluster by EOL Coding procedure in the End of Line. DTC will be set if the optional information is different when comparied between memorized optional information from CAN-BUS and optional information sent by EOL. In the assembly line, EOL communication will be finished in case that DTC is not set during DTC searching.
In service field, it is necessary to set cluster by using variant coding procedure with GDS in order to syncronize the opitional parts on the vehicle after replacing cluster.




IPM: Intelligent integrated Platform Module SMK: Smart Key DDM: Driver Door Module ADM: Assistant Door Module PSM: Power Seat Module MFSW: Multi-Function Switch SWRC: Steering Wheel Remote Controller IMS SW:Integrated Memory System Switch SCM: Steering Column Module PCU: Power-train Control Unit ECU: Engine Control Unit EPB: Electronic Parking Brake ABS: Anti-lock Brake System ESC: Electronic Stability Control SCC: Smart Cruise Control CLUM: Cluster Module DATC: Dual Automatic Temp. Control SCC: Smart Cruise Control MDPS: Motor Driven Power Steering SAS: Steering Angle Sensor TPMS: Tire Pressure Monitoring System SRSCM: Supplemental Restraints System Control Module HU: Head Unit RRC: Rear Remote Control AMP: Amplifier

DTC Description

This DTC means that it is not programmed Cluster in the End of Line. Virgin status.
After assembling vehicle or replacing cluster, it is essential to perform coding procedure for the culuster in order to put in the optional information. If the coding procedure has not performed or made incorrect coding, this DTC will be set so that technicians can recognize it. This DTC can be set from assembly line and will be erased if the EOL programming is completed successfully.
** Cluster Message in case of Virgin status or EOL programming error : "Coding error" will be displayed at LCD monitor on the Cluster.

DTC Detecting Condition





Diagnostic Circuit Diagram










Signal Waveform & Data








Fig.1) C_CAN Low/High Signal Waveform
Fig.2) C_CAN BUS Voltage Level (High Speed CAN)