W/Harness Inspection

PODS-F
B1493 OCS(Occupant Classification System) Communication error - Inspection/Repair:_:W/Harness Inspection

Terminal and Connector Inspection

1. Many malfunctions in the electrical system are caused by poor harness and terminals.
Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
2. Thoroughly check shorting bar/shorting bar release pin and connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
3. Has a problem been found?






Power Circuit Inspection

1. Check for an open or short circuit in the SRSCM Power Circuit.
(1) Disconnect SRSCM connector from wiring harness.
(2) Ignition "ON" & Engine "OFF".
(1) Measure voltage between terminal "supply voltage" and chassis ground.

Specification :Battery Voltage




(3) Is the measured voltage within specifications?






CAN communication Line Inspection

1. Connect SRSCM and Passenger side PODS-F sensor Mat & ECU connector.
2. IG KEY ON.
3. Measure signal waveform between C-CAN HIGH terminal and C-CAN LOW terminal of SRSCM connector.

Specification :Refer to Signal waveform and Data




4. Is the measrured signal waveform normal ?