Component Inspection

Driver Door Module
B1911XX Outside Mirror - Left Vertical Motor or Sensor Error - Inspection/Repair:_:Component Inspection

Component Inspection

Check mirror motor
1. Connect GDS.
2. IG "ON" & ENG "OFF".
3. Select "Actuation Test" mode.
4. Execute "LH Outside Mirror (UP, DOWN)" test.

Specification :Turned to pressed direction




Fig.1) Actuation test of the outside mirror vertical motor at the driving seat side
5. Is motor working normal ?





Check switch
1. IG "ON" & ENG "OFF".
2. After connect GDS, select "Current Date" menu.
3. Change an outside mirror select switch into a driver operating mode.
4. Check if a power of a driver outside mirror vertical sensor changes normally when operating the outside mirror switch into the UP/DOWN side.

Specification :
Approx. 0.46V - Voltage at the minimum operation to down
Approx. 4.16V - Voltage at the maximum operation to up








Fig.1) The current data of outside mirror vertical sensor's power at the driver side - Voltage at the maximum operation to up (Approx. 4.16V)
Fig.2) The current data of outside mirror vertical sensor's power at the driver side - Voltage at the minimum operation to down (Approx. 0.46V)
5. Is the service data normal ?