Component Inspection

Engine Control
P0336 Crankshaft Position Sensor - Inspection/Repair:_:Component Inspection

Component Inspection

Visually check CKPS and target wheel
1. IG "OFF"
2. Check CKPS and target wheel for deformation or damage visually
3. Is the above items normal ?





Check CKPS
1. IG "OFF" and disconnect CKPS connector.
2. Measure resistance between low signal and high signal terminals of CKPS connector.(Component side)

Specifiation :500 - 620Ohms [25°C(77°F)]




3. Is the measured siganl waveform normal ?





Check signal waveform of CKPS
1. IG "OFF" and connect GDS.
2. ENG "ON" and Measure signal waveform at signal terminal of CKPS.




Fig.1) Normal waveforms of CKPS & CMPS




3. Is the measured siganl waveform normal ?