General Information

Engine Control
P0462 Fuel Level Sensor - General Information

Component Location





General Description

PCM monitors the voltage output signals of the Fuel Level Sensor (FLS) (#1) and the Fuel Sub Sender (#2). The combined resistance of the two sensors in series enables the fuel gage to determine fuel tank level. PCM also uses values from both sensors to determine condition of the EVAP system for leak detection. PCM monitors both fuel level sensors for the conditions of being stuck high or low, and differences between voltages of fuel level sensors. PCM will calculate if voltage deviation of fuel level sensors has exceeded a limit value while driving. This would be interpreted by the PCM as a fault.

DTC Description

PCM monitors output signals of fuel sub sender #2. If the fuel level voltage is lower than 0.36V, PCM sets a P0462 DTC. The Malfunction Indicator Lamp (MIL) turns on when the malfunction lasts two consecutive driving cycles.

DTC Detecting Condition





Specification





Diagnostic Circuit Diagram