Repair Procedures

Removal

Front View Camera
1. Remove the front bumper.

2. Loosen 3 screws and disconnect the connector(6 pins). Remove the front view camera(A).





Back View Camera
1. Open the trunk and remove the rear garnish assembly.

2. Disconnect the connector and loosen 2 screws. And remove the back view camera(A).





Front View Camera Switch
1. Disconnect the negative (-) battery terminal.
2. Remove the crash pad lower panel in the driver side.

3. Remove the crash pad switch assembly(A) by pushing both clips.

CAUTION:
Wear the glove not to damage your hands.

Installation

Front View Camera
1. Install the front view camera.
2. Install the front bumper.

Back View Camera
1. Install the rear view camera.
2. Install the rear garnish assembly.

Front View Camera Switch
1. Connect the connector and install the side switch assembly.