Repair procedures

Replacement

CAUTION:
- When removing and installing the hood, an assistant is necessary.
- Be careful not to damage the hood and body.
- When removing the clips, use a clip remover.

1. Using a screwdriver, lift the socket clips (A) up slightly on both ends of the lifter (B).




2. After loosening the hood hinge (A) mounting bolts, remove the hood panel (B).

Tightening torque :
21.6 - 26.5 N.m (2.2 - 2.7 kgf.m, 15.9 - 19.5 lb-ft)




3. Installation is the reverse of removal.

NOTE:
- Make sure the hood locks/unlocks and opens/closes properly.
- Adjust the hood alignment.