Repair procedures

Replacement

CAUTION:
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
- Take care not to scratch the body surface.
- Put on gloves to protect your hands.

1. Using a screwdriver or remover, remove the center facia side garnish (A).




2. Remove the gear boots (B) and gear knob (A).




3. Using a screwdriver or remover, remove the console upper tray complete (A).




4. Disconnect the connectors (A).




5. Remove the console tray (A).




6. Remove the console tray met (A).




7. After loosening the mounting screws and bolts, then remove the console rear complete assembly (A).




8. Disconnect the connector (A).




9. Using a screwdriver or remover, remove the console extension cover (A).




10. After loosening the mounting screws, then remove the console front complete assembly (A).

NOTE:
- Shift lever to "N" position when remove the console front complete assembly.




11. Disconnect the connectors (A).




12. Installation is the reverse of removal.

NOTE:
- Make sure the connector are connected in properly.
- Replace any damage clips.