Repair procedures

Adjustment

Inspect Glass Alignment
1. Check for abnormal noise or bending during operation.
2. With the sunroof fully closed, check for water leakage.
3. The roof panel (B) should be even with the movable glass (A) weatherstrip, to within the standard value "E" all the way around. If not, make the following adjustment.

Tightening torque :
Standard value "E" [mm(in.)]
(1) Front edge : 1.2 mm (0.0472 in.)
(2) Rear edge : 1.0 mm (0.0394 in.)




4. If the position is not as specified, lightly loosen the glass adjusting screws (A) to adjust the glass height and tighten it.

CAUTION:
- Do not damage the screws.





Operating The Panorama roof Emergency Handle
1. Use the Panorama roof emergency handle to close and open the Panorama roof manually for the following case only.
A. To close the Panorama roof before driving a vehicle in a rainy day or on the highway if the Panorama roof can not be closed due to failure of the Panorama roof motor or controller.
2. Operating method.
A. Remove the roof trim.
B. Push the emergency handle up into the hexagonal drive of the Panorama roof motor. You must push hard enough to disengage the motor clutch; otherwise the emergency handle will slip due to incomplete fit in the motor.
C. Carefully turn the emergency handle clockwise to close the Panorama roof.
D. After closing the sunroof, wiggle the handle back and forth as you remove the tool from the motor, to ensure the motor clutch reengages.
E. A 5mm hex socket may be used in place of the emergency handle, with a" Speeder" type handle.

CAUTION:
- Do not use power tools to operate the Panorama roof.
- Damaged to the components may occur.