Repair procedures

Replacement

CAUTION:
- Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
- Take care not to bend or scratch the trim and panels.
- Put on gloves to protect your hands.

1. Remove the rear seat assembly.

2. Disconnect the connectors (A), and mounting wireing clips (B).




3. After loosening the mounting screws, then remove the rear back armrest board (A).




4. After loosening the mounting bolts, then remove the rear back armrest (A).




5. Push the lock pin (B), remove the headrest (A).




6. After loosening the mounting screws, then remove the rear seat back webbing guide (A).




7. Pull out the headrest guides (A) while pinching the end of the guides, and remove them.




8. Remove the hog-ring clips (A).




9. After removing the velcro tape (A) and hog-ring clips (B) on the rear of seat back and remove the rear seat back cover (C).




10. Installation is the reverse of removal.

NOTE:
- To prevent wrinkles, make sure the material is stretched evenly over the cover (B) before securing the hog-ring clips (A).
- Replace the hog-ring clips with new ones using special tool [C (09880-4F000)].