Turn Signals: Service and Repair

Rear Combination Lamp (Outside)

1. Disconnect the negative (-) battery terminal.
2. If the bulbs should be only replaced without removing lamp assembly, replace the turn signal lamp bulb (A).








3. Remove the nuts (4EA).




4. Remove the rear combination lamp (A) after disconnecting the connector.





Rear Combination Lamp (Inside)
1. Disconnect the negative (-) battery terminal.
2. If the bulbs should be only replaced without removing lamp assembly, replace the back up lamp bulb (A) after removing the trim cover in the trunk.




3. Remove the rear garnish assembly (A).






Installation

1. Install the rear combination lamp assembly after assembling the bulb.