Repair Procedures

Removal and Installation

[LH]
1. Disconnect the battery negative terminal.
2. Remove the engine cover.
3. Disconnect the LH ignition coil connectors (A) and then remove the LH ignition coils.

Tightening torque :
9.8 - 11.8N.m (1.0 - 1.2kgf.m, 7.2 - 8.7lb-ft)





NOTE:
When disconnecting the ignition coil connector, pull out the locking pin (A) and then pull out the connector while pressing the clip (B).




4. Installation is reverse order of removal.
[RH]
1. Disconnect the battery negative terminal.
2. Remove the surge tank.

3. Disconnect the RH ignition coil connectors (A) and then remove the RH ignition coils.

Tightening torque :
3.9 - 5.9N.m (0.4 - 0.6kgf.m, 2.9 - 4.3lb-ft)





NOTE:
When disconnecting the ignition coil connector, pull out the locking pin (A) and then pull out the connector while pressing the clip (B).




4. Installation is reverse order of removal.

Inspection

1. Measure the primary coil resistance between terminals (+) and (-).





Standard value :0.75Ohms±15%