Repair Procedures

Removal

1. Remove the center console assembly.

2. Remove the duct (A).




3. Remove the control cable (B).




4. Remove the control cable assembly in the vehicle after removing the nuts (B) and the retainer (A).

Tightening torque:
9.8 - 14.7 N.m (1.0 - 1.5 kgf.m, 7.2 - 10.9 lb-ft)




5. Remove the nut (C).
6. Remove the cable (B) from the bracket (A) at transaxle assembly side.





7. Remove the control cable inside of cab.

Installation

1. Installation is the reverse of removal.

NOTE:
Make sure vehicle does not roll before setting room side shift lever and Automatic Transaxle(AT) side manual control lever to "N" position.

Adjustment

Adjusting method for T/M control cable
1. Make sure vehicle does not roll before setting room side shift lever and Automatic Transaxle(AT) side manual control lever to "N" position.
2. Connect room side shift lever and control cable.
3. Push cable to "F" direction shown to eliminate FREE PLAY.
4. Tighten adjusting nut (A).

Tightening torque:
9.8 - 14.7 N.m (1.0 - 1.5 kgf.m, 7.2 - 10.9 lb-ft)




5. After adjusting, check to be sure that this part operates as designed at each range of Automatic Transaxle(AT) side corresponding to each position of room lever.