Power Window Switch: Service and Repair

Inspection

Driver Power Window Switch
1. When checking the driver power window switch, select a vehicle type and "IPM" menu.
2. Select "DDM (Driver Door Module)".
3. Select option "Input/Output monitoring".

4. To check the input value of power window switch in force mode, select option "ACTUATION TEST".

Assist Power Window Switch
1. When checking the assist power window switch, select a vehicle type and "IPM" menu.
2. Select "ADM (Assist Door Module)".
3. Select option "Input/Output monitoring".

4. To check the input value of power window switch in force mode, select option "ACTUATION TEST".

Removal

Driver Power Window Switch
1. Disconnect the negative(-) battery terminal.
2. Remove the front door trim panel.

3. Disconnect the power window switch module connector (A) from the wiring harness.

4. Remove the power window switch module (B) from the door trim after loosening the mounting screws.

NOTE:
- Be careful not to damage door trim panel and door module mounting hooks.

Passenger Power Window Switch
1. Disconnect the negative (-) battery terminal.
2. Remove the front door trim panel.

3. Disconnect the connector from the power window switch module.
4. Remove the power window switch module (A) from the door trim after loosening the mounting screws.

5. Remove the power window switch after loosening screws.
Rear Power Window Switch
1. Disconnect the negative (-) battery terminal.
2. Remove the rear door trim panel.

3. Disconnect the connector (A) from the power window switch module.
4. Remove the power window switch module (B) from the door trim after loosening the mounting screws.

5. Remove the power window switch (A) after loosening the fixing clip.

Installation

1. Install the power window switch module.
2. Install the door trim panel after reconnecting the relevant connectors

NOTE:
- Make sure that the power window switch module connectors are plugged properly.
- Check that the power window switch and door lock switch operate normally.