Repair Procedures

Replacement

Sunvisor Replacement

NOTE:
- Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
- Put on gloves to protect your hands.

1. Loosen the mounting screws, then remove the sunvisor (A) and retainer (B).




2. Installation is the reverse of removal.

Assist Handle Replacement

NOTE:
- Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
- Put on gloves to protect your hands.

1. Remove the covers (A) and screws, then remove the assist handle (B).




2. Installation is the reverse of removal.

Garment Hook Assembly Replacement

NOTE:
- Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
- Put on gloves to protect your hands.

1. Remove the cover (B).
2. After loosening the mounting bolt, then remove the garment hook assembly (A).




3. Installation is the reverse of removal.

Overhead Console Replacement

NOTE:
- Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
- Put on gloves to protect your hands.

1. After loosening the mounting screws, then remove the overhead console assembly (A).




2. Disconnect the connectors (B).




3. Installation is the reverse of removal.

NOTE:
- Make sure the connector is connected properly.

Vanity Lamp Replacement

NOTE:
- Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
- Put on gloves to protect your hands.

1. Using a screwdriver or remover, remove the vanity lamp (B).
2. Disconnect the vanity lamp connector (A).




3. Installation is the reverse of removal.

NOTE:
- Make sure the connector is connected properly.

Hands Free Mic Replacement

NOTE:
- Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
- Put on gloves to protect your hands.

1. Using a screwdriver or remover, remove the hands free mic (A).
2. Disconnect the hands free mic connector (B).




3. Installation is the reverse of removal.

NOTE:
- Make sure the connector is connected properly.

Roof Trim Replacement

NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
- Put on gloves to protect your hands.

1. Remove the front seat assembly.

2. Remove the rear seat assembly.

3. Remove the sunvisor and retainer.
4. Remove the overhead console.
5. Remove the assist handle.
6. Remove the garment hook assembly.
7. Remove the front pillar trim.

8. Remove the front door scuff trim.

9. Remove the rear door scuff trim.

10. Remove the center pillar lower trim.

11. Remove the center pillar upper trim.

12. Remove the rear pillar trim.

13. Remove the ECM mirror cover (B).
14. Disconnect the ECM mirror connector (A).




15. Remove the auto defog sensor cover (B).
16. Disconnect the auto defog sensor connector (A).




17. Disconnect the connector (A) and the mounting clips in the front pillar.
[Driver's]




[Passenger's]




18. Remove the clips and roof trim (A).




19. Installation is the reverse of removal.

NOTE:
- Make sure the connectors are plugged in properly.
- Replace any damage clips.