Repair Procedures

Removal and Installation

1. Loosen the drain plug, and drain the engine coolant. Remove the radiator cap to drain with speed.
2. Disconnect the battery negative terminal.
3. Remove the air cleaner assembly.

4. Disconnect the water temperature sensor connector (A).
5. Disconnect the radiator upper hose (B).
6. Remove the heater hose (C).
7. Disconnect the water hose (D).




8. Remove the water temperature control assembly (B).

Tightening torque :
9.8 - 11.7N.m (1.0 - 1.2kgf.m, 7.2 - 8.7lb-ft)




9. Install in the reverse order of removal.

CAUTION:
Clean the surface of the water temperature control assembly before installing.