Disassembly and Assembly

Disassembly and Assembly





- When disassembling and assembling, unlock steering lock with key.
- Remove combination switch.
- Ensure that rounded surface of snap ring faces toward bearing when snap ring is installed.
- Install snap ring on upper shaft with a suitable tool.
- Steering lock





a. Break self-shear type screws with a drill or other appropriate tool.





b. Install new self-shear type screws and then cut off self-shear type screw heads.

Inspection





- When steering wheel does not turn smoothly, check the steering column as follows and replace damaged parts.
a. Check column bearings for damage or unevenness. Lubricate with recommended multi-purpose grease or replace steering column as an assembly, if necessary.
b. Check jacket tube for deformation or breakage. Replace if necessary.
- When the vehicle comes into a light collision, check length "L".
Column length "L": 535.9 - 538.1 mm (21.10 - 21.18 inch)
If out of the specifications, replace steering column as an assembly.

TILT MECHANISM





- After installing steering column, check tilt mechanism operation.