Removal and Installation

CRASH ZONE SENSOR

Removal and Installation


WARNING:
- Before servicing, turn ignition switch OFF, disconnect battery negative terminal and wait for 3 minutes or more.
- Never use the air tools or the electric tools for servicing.

REMOVAL

1.Remove the reservoir tank. Exploded View.
2.Remove the crash zone sensor mounting nuts.
3.Disconnect the crash zone sensor harness connector.

CAUTION:





- Never impact the crash zone sensor.


- Replace the crash zone sensor if it is dropped or sustains an impact.
- Replace the crash zone sensor of deployed the driver air bag and deployed the passenger air bag.

INSTALLATION

Note the following items, and then install in the reverse order of removal.

CAUTION:
- Never reuse mounting nuts after removal, replace with the new nuts.
- Never damage the harness while installing.
- If malfunction is detected by the air bag warning lamp, after repair or replacement of the malfunctioning parts, reset the memory using self-diagnosis or CONSULT. Air Bag Warning Lamp Diagnosis or Scan Tool Testing and Procedures.
- After the work is completed, check that no system malfunction is detected by air bag warning lamp.