Removal and Installation

SATELLITE SENSOR

Removal and Installation


WARNING:
- Before servicing, turn ignition switch OFF, disconnect battery negative terminal and wait for 3 minutes or more.
- Never use the air tools or the electric tools for servicing.

REMOVAL

1.Remove the front seat belt retractor. Removal and Installation.
2.Remove the satellite sensor mounting nuts.
3.Disconnect the harness connector, and then remove the satellite sensor.

CAUTION:





- Never impact the satellite sensor.


- Replace the satellite sensor if it is dropped or sustains an impact.
- Replace the satellite sensor of deployed the side air bag module and deployed the curtain air bag module.

INSTALLATION

Note the following items, and then install in the reverse order of removal.

CAUTION:
- Never reuse mounting nuts after removal, replace with the new nuts.
- Never damage the harness while installing.
- If malfunction is detected by the air bag warning lamp, after repair or replacement of the malfunctioning parts, reset the memory using self-diagnosis or CONSULT. Air Bag Warning Lamp Diagnosis or Scan Tool Testing and Procedures.
- After the work is completed, check that no system malfunction is detected by air bag warning lamp.