Removal and Installation

REAR DOOR GLASS

Removal and Installation


REMOVAL

1.Remove the rear door finisher. Removal and Installation.
2.Remove the rear door outside molding. .
3.Remove the rear door inside molding.
4.Remove partially the sealing screen.





5.Remove the door glass run (1) on the partition sash side.
6.Remove the partition sash (2) fixing bolts (shown by the arrows), and remove the partition sash.
7.Reconnect the power window switch finisher.





8.Operate the power window switch to raise/lower the door window until the glass mounting bolts can be seen.
9.Remove the glass mounting bolts shown by the arrows in the figure.
10.Remove the door glass from the inside of door panel.
11.Remove the door glass run.





12.Remove the partition glass from door panel.

INSTALLATION

Install in the reverse order of removal.