C1144

C1144 INCOMPLETE STEERING ANGLE SENSOR ADJUSTMENT

DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. DTC REPRODUCTION PROCEDURE

1.Turn the ignition switch ON.
2.Select "ABS", "WORK SUPPORT" and "ST ANGLE SENSOR ADJUSTMENT" in order with CONSULT-III, and perform adjust the neutral position of steering angle sensor.
3.Perform self-diagnosis for "ABS" with CONSULT-III.
Is DTC "C1144" detected?
YES- Proceed to diagnosis procedure. .
NO- INSPECTION END


Diagnosis Procedure


1. CHECK STEERING ANGLE SENSOR

Check steering angle sensor. C1143.
Is the inspection result normal?
YES- Replace ABS actuator and electric unit (control unit).
NO- Repair or replace error-detected parts.


Special Repair Requirement


1. ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION

Always perform the neutral position adjustment for the steering angle sensor, when replacing the ABS actuator and electric unit (control unit) or steering angle sensor and removing steering angle sensor. Special Repair Requirement
- END