Hood Hinge Bracket
Hood Hinge BracketREMOVAL PROCEDURE
1. Remove all of the related panels and components.
2. Restore as much of the damage as possible to the factory specifications.
3. Note the location and remove the following as necessary:
- Sealers
- Sound deadeners
- Anti-corrosion materials
IMPORTANT: Do not damage any of the inner panels or reinforcements. Drill through the hinge bracket only.
4. Locate and drill out all factory welds. Note the number and location of welds for installation of the service part.
5. Remove the Hood Hinge Bracket.
INSTALLATION PROCEDURE
IMPORTANT: In any area damaged beyond recognition, space the plug weld holes every 40 mm (1 1/2 in.) apart.
1. Drill 8 mm (5/16 in.) plug weld holes in the service part as necessary in the locations noted from the original part.
2. Prepare all of the attachment surfaces as necessary.
3. Apply a weld-thru primer to all of the bare metal surfaces.
4. Position the hinge bracket.
5. Plug weld accordingly.
6. Clean and prepare all of the welded surfaces.
IMPORTANT: Prior to refinishing, refer to publication GM4901M-D-01 GM Approved Refinish Materials for recommended products. Do not combine the paint systems. Refer to the paint manufacturer's recommendation.
7. Apply sound deadening materials.
8. Apply an approved anti-corrosion primer.
9. Apply sealers and refinish as necessary.
10. Install all of the related panels and components.