Trim Panel Replacement - Knee Bolster

Trim Panel Replacement - Knee Bolster

Removal Procedure

1. Remove the left closeout/insulator panel.




2. Remove the 4 trim panel retaining screws.
3. Release the clips that retain the trim panel to the IP.
4. Remove the trim panel from the IP.

Installation Procedure




1. Position the trim panel to the IP.
2. Seat the clips that retain the trim panel to the IP.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the 4 trim panel retaining screws.

Tighten the screws to 2.5 N.m (22 lb in).

4. Install the left closeout/insulator panel.