Blower Motor Resistor Assembly Replacement

Blower Motor Resistor Assembly Replacement

Removal Procedure
1. Remove the right closeout/insulator panel.
2. Disconnect the blower motor resistor electrical connector (3).
3. Remove the blower motor resistor mounting screws (2).




4. Remove the blower motor resistor (1).

Installation Procedure
1. Install the blower motor resistor (1).

NOTE: Refer to Fastener Notice in Cautions and Notices.

2. Install the blower motor resistor mounting screws (2).

Tighten
Tighten the screws to 1.9 Nm (17 lb in).

3. Connect the blower motor resistor electrical connector (3).




4. Install the right closeout/insulator panel.