Blower Motor Resistor Replacement - Auxiliary

Blower Motor Resistor Replacement - Auxiliary

Removal Procedure
1. Remove the rear HVAC module assembly.
2. Disconnect the electrical connector from the blower motor control processor-auxiliary (3).
3. Remove the screws from the blower motor control processor-auxiliary (3).
4. Remove the blower motor control processor-auxiliary (3).




5. Remove the thermal gasket from the evaporator core-auxiliary surface.

Installation Procedure
1. Install the thermal gasket to the blower motor control processor-auxiliary.
2. Install the blower motor control processor-auxiliary (3).

NOTE: Refer to Fastener Notice in Cautions and Notices.

3. Install the screws to the blower motor control processor-auxiliary (3).

Tighten
Tighten the screws to 2 Nm (18 lb in).

4. Connect the electrical connector to the blower motor control processor-auxiliary (3).




5. Install the HVAC module-auxiliary.