Transfer Case Input Shaft Seal Replacement

Transfer Case Input Shaft Seal Replacement

Tools Required
^ J42738 Seal Installer

Removal Procedure
1. Raise the vehicle.





2. Remove the transfer case assembly.

Notice: Refer to Transfer Case Seal Removal Notice in Service Precautions.

Notice: Do not damage the sealing surfaces of the transfer cases or the shafts when prying the seals for removal. Damaging the sealing surface may cause leakage or require replacement of the damaged component





3. Insert a flat bladed screw driver between the input shaft seal and the transfer case.
4. Pry the front input shaft seal from the transfer case.
5. Remove the front input shaft seal.

Installation Procedure





1. Align the input shaft seal on the input shaft.
2. Using the J42738, install the input shaft seal.
3. Install the transfer case assembly.
4. Inspect the transfer case fluid level.
5. Lower the vehicle.