Rear Shock Absorber

Shock Absorber Replacement

Removal Procedure
1. Raise and support the vehicle.

Notice: The rear axle must not be allowed to hang freely while servicing rear suspension components. Not supporting the rear axle will result in damage to the upper control arm and/or to the air suspension components.

2. Support the rear axle.





3. Remove the shock absorber upper mounting bolt.
4. Remove the shock absorber lower mounting bolt.





5. Remove the shock absorber from the vehicle.

Installation Procedure
1. Install the shock absorber to the vehicle.

Notice: Refer to Fastener Notice in Service Precautions





2. Install the shock absorber lower mounting bolt.
^ Tighten the shock absorber lower mounting bolt to 80 Nm (59 ft. lbs.).
3. Install the shock absorber upper mounting bolt.
^ Tighten the shock absorber upper mounting bolt to 80 Nm (59 ft. lbs.).

Important: Before removing the support from the rear axle, ensure that the air suspension leveling sensor link is in the correct position. If the air suspension leveling sensor link is out of position, air suspension system failure will occur.

4. Remove the support from the rear axle.





5. Lower the vehicle.