Axle Assembly

Removal
1. Remove the axle shafts.





2. CAUTION: Under no circumstances must the flexible coupling (or its fixings) be loosened or removed from the driveshaft.

Detach the driveshaft from the differential flange.
Mark the position of the driveshaft in relation to the differential flange.
Mark the position of the balance nut in relation to the differential flange (if fitted).
Mark the position of each nut and bolt in relation to the transmission flexible joint.





3. Disconnect the axle assembly breather tube from the crossmember.

4. CAUTION: When supporting the axle assembly, use a suitable packing material to prevent damage to the underside of the casing.

Support the axle assembly.





5. NOTE: Take care not to lose the washer when removing the forward axle retaining bolt.

Remove the axle assembly.

Installation








1. NOTE: Take care not to mix up the washer positions when installing the forward axle retaining bolt.

NOTE: Make sure that the driveshaft nuts and bolts are refitted in the correct locations.

To install, reverse the removal procedure.