Shifter M/T: Service and Repair

Removal
1. Remove the shift linkage assembly.





2. Detach the shift linkage gaiter.





3. Remove the selector rod retaining clip.





4. Remove the selector rod.





5. Release the nylon insert retaining tangs.





6. Remove the gearshift lever assembly.





7. Remove the nylon insert.

Installation








1. NOTE: Make sure the gear lever is upright in 3-4 neutral before reconnecting the lever to the selector rod.

NOTE: Make sure the arrow on the gear lever gaiter is pointing forward before installing.

To install, reverse the removal procedure.
Apply polyglup SSD-M1C244-A or equivalent.