Glove Box Lamp Assembly

Removal
1. Open glovebox lid.





2. Carefully release and remove plastic lens from glovebox light.
3. Remove bulb from glovebox light.





4. Release light/switch assembly retaining tangs and partially withdraw assembly from glovebox exterior.





5. Position light/switch assembly for access, disconnect harness spade connectors and remove assembly from glovebox aperture.


Installation
1. Position light/switch assembly at glove box aperture and connect harness spade connectors.
2. Install light/switch assembly in aperture, ensuring that retaining tangs are fully seated.
3. Install bulb in light/switch assembly.
4. Check that harness leads are not in contact with the bulb glass.
5. Install plastic lens on light/switch assembly.
6. Close glovebox lid.