Rear Quarter Casing

Removal
1. Position front seat fully forward.
2. Remove rear seat cushion and squab.







3. Remove rear quarter capping.
1. Remove fastener retaining rear quarter capping to 'B' post extension.
2. Slacken and remove three screws retaining the capping, lift capping clear and remove from vehicle.







4. Remove front seat belt upper anchor plate and trim.
1. Unclip front seat belt upper anchor plastic cover and position for access to retaining nut.
2. Slacken and remove seat belt upper anchor retaining nut.
3. Remove seat belt upper anchor and plastic cover.

5. Remove front seat belt escutcheon.







6. Detach front seat belt lower anchor bar.
1. Slacken and remove front seat belt lower anchor bar retaining bolt.
2. Remove anchor bar from body grommet and seat belt loop.
3. Retain anchor bar spacer and card washer.







7. On convertible model rear quarter casing, release clips from locations in the 'B' post and two dowels from seat squab panel, and position casing for access.







8. Disconnect 'B' post occupancy sensor electrical connector.







9. Pass seat belt anchor plates through rear quarter casing apertures and remove casing from vehicle.

Installation







1. Position rear quarter casing and engage two dowels in rear seat squab panel.
2. Pass seat belt anchor plates through casing apertures.
3. Connect 'B' post passenger restraint sensor electrical connector.
4. Press home and fully seat the remaining casing clips in body locations.
5. Position and seat front seat belt escutcheon to casing aperture.
6. Fit front seat belt anchor bar.
1. Pass front seat belt anchor bar through seat belt loop and body grommet.
2. Fit retaining bolt to seat belt anchor bar.
3. Fit spacer and card washer and locate and fully tighten retaining bolt.

7. Fit front seat belt upper anchor plate.
1. Fit plastic cover to front seat belt upper anchor plate retaining stud.
2. Position upper anchor plate on retaining stud and fit and tighten retaining nut.
3. Fasten upper anchor plastic cover.
8. Position rear quarter capping, secure to 'B' post extension with fastener and fit and tighten three screws.
9. Fit rear seat squab and cushion.