Replacement of Rear Door Latch.
Refer to workshop manual section 76 pages 25,261. Ensure the window is in the closed position.
2. Remove the interior handle escutcheon using a No. 2 screwdriver.
3. Remove 2-off interior handle screws using a No. 2 screwdriver.
4. Carefully pry the casing away from the door.
5. Disconnect the mid range speaker, where fitted.
6. Carefully peel back the water curtain to speaker level.
7. Remove sill button.
8. Drill 3 rivets from 2 interior handle brackets using a 5 mm drill. Rivet (P/N RA612157).
9. Remove brackets.
10. Lower window to allow access to the butterfly clips.
11. Remove clips off ball studs.
12. Pull window -X- from channel and push glass back up.
13. Disconnect latch.
14. Disconnect regulator.
15. Cut off 6 grey harness clips and discard. Clip (P/N YQR 10075).
16. Pull window lift switch forward to remove from handle casing, Do not disconnect.
17. Remove latch screws using a screwdriver and TX25 bit.
18. Drill out rivets (4 off) in brose plate - ensure correct rivets are drilled using a 5 mm drill.
19. Lift out plate assembly.
Note:
Fit new cable clips for harness (P/N YQR 10057).
Take care not to break off child lock button on reassembly.
When the door has been reassembled, operate exterior handle 3 to 4 times. Remove the rubber plug in the edge of the door by latch, insert a 3 mm Allen key and secure the pre-load screw finger tight refit plug. where the Workshop Manual, in section 86 page 32 item NO 11 states 4 bolts, they are actually pop rivets.
Refer to previous section for electrical checks for rear door.