Rear
BRAKE DISC AND SHIELD - REARRemove
1. Remove rear brake pads. Refer to Rear Brake Pad Service and Repair
2. Remove 2 bolts securing caliper.
3. Tie caliper aside, ensuring brake hose is not stressed.
4. Remove screw securing disc, remove disc.
5. Using a wire brush, remove corrosion from disc mating faces before cleaning with a suitable solvent.
6. Remove 3 bolts, remove disc shield.
7. Remove 2 bolts, remove shield strap.
Refit
8. Fit shield strap, secure with bolts. Tighten to 8 Nm. (6 ft lbs)
9. Fit disc shield, fit securing bolts. Tighten to 8 Nm. (6 ft lbs)
10. Fit brake disc, secure with screw. Tighten to 25 Nm. (18 ft lbs)
11. Untie brake caliper.
12. Fit brake caliper, fit bolts. Tighten to 100 Nm. (74 ft lbs)
13. Fit rear brake pads. Refer to Rear Brake Pad Service and Repair