Front Fender: Service and Repair

76.10.24 Wing - Front - Up To 03MY

Remove

1. Remove front repeater lamp.
2. Remove front wheel arch liner.







3. Remove 5 screws securing wheel arch liner extension to bumper valance and remove liner.







4. Remove side repeater lamp from wing, disconnect multiplug and remove lamp.







5. Remove bolt securing front of wing to bracket on body.
6. Remove screw securing headlamp surround panel to wing.







7. Remove nut securing wing to bracket on sill finisher.







8. Remove 8 bolts securing wing to body and remove wing.

Refit

1. Position wing to body.
2. Connect side repeater lamp to multiplug and fit to wing.
3. Position wing to body, align wing to bonnet and front door so that the correct gaps are achieved and tighten bolts to 17 Nm (13 lbf.ft).
4. Check alignment of wing to bonnet and front door. If necessary, adjust wing to achieve correct gaps.
5. Fit and tighten nut securing wing to bracket on sill finisher to 17 Nm (13 lbf.ft).
6. Fit and tighten screw securing wing to headlamp surround panel.
7. Fit and tighten bolt securing front of wing to bracket on body to 17 Nm (13 lbf.ft).
8. Fit wheel arch liner extension to bumper and secure with screws.
9. Fit front wheel arch liner.
10. Fit front repeater lamp.