Trim Casing - Side - Loadspace

76.13.12 Trim Casing - Side - Load Space

Remove

1. Models with third row seats: Remove third row seat.
2. For LH trim casing: Remove accessory socket.
3. Remove 'D' post trim casing.







4. Remove screw securing trim cap to trim casing.
5. Release trim cap from trim casing.
6. Models with ICE headphone control panels: Disconnect multiplug from headphone control panel and remove trim cap.
7. Partially remove rear door aperture seal.
8. Remove 2 trim clips securing trim casing to body.
9. Remove access panel.
10. Remove trim clip securing trim casing to lower 'D' post.
11. Models without third row seats: Remove trim clip from bottom rear corner of trim casing.
12. Release trim casing to gain access to rear seat belt reel.







13. Remove bolt securing rear seat belt reel to body.
14. Remove trim casing.

Refit

1. Position trim casing.
2. Fit rear seat belt reel to body and tighten bolt to 50 Nm (37 lbf.ft).
3. Models without third row seats: Fit trim clip securing bottom rear corner of trim casing.
4. Fit trim clip securing trim casing to lower 'D' post.
5. Fit access panel to trim casing.
6. Fit trim clips securing trim casing to body.
7. Fit rear door aperture seal.
8. Models with ICE headphone control panels: Position trim cap and connect multiplug to headphone control panel.
9. Fit trim cap to trim casing and secure with screw.
10. Fit 'D' post trim casing.
11. Fit accessory socket.
12. Models with third row seats: Fit third row seat.