Cover - Squab - Front Seat

78.90.08.81 Cover - Squab - Front Seat

Remove

1. Remove front seat.
2. Place seat on a suitable work bench.







3. Tighten arm rest adjuster fully clockwise and remove screw cover.
4. Remove screw securing arm rest to seat and remove arm rest.







5. Remove 2 screws securing outer edge trim casing to seat frame.
6. Remove trim casing.
7. Release inner edge of trim casing from seat frame.
8. Remove trim casing.







9. Position seat upside down on table.
10. Release clip securing lower edge of squab cover to seat frame.
11. Remove 2 clips securing either end of cover to squab frame.







12. Position seat in upright position.
13. Raise headrest to maximum height.
14. Turn both guides through 90 degrees.
15. Remove headrest from seat.
16. Remove screws securing grab handles to seat frame and remove grab handles.







17. Release clip securing front of cover to squab frame.
18. Release hooks from squab frame.







19. Fold cover upwards over squab until first row of hog rings are visible.
20. Remove first row of hog rings.
21. Fold cover upwards over squab until second row of hog rings are visible.
22. Remove second row of hog rings.







23. Push out centres of trim clips securing stowage pocket elastic to seat frame.
24. Remove trim clip outers.
25. Release hooks from seat frame and feed though to front of foam.







26. Fold cover upwards until third row of hog rings are visible.
27. Remove third row of hog rings.
28. Remove hog rings securing rear of squab cover to seat frame.
29. Release bar from seat frame.







30. Remove headrest guides.
31. Fold cover fully upwards and remove.

Refit

1. Fit squab cover to top of seat. Do not fold down too far onto seat.
2. Fit headrest guides.
3. Fit grab handles to seat and secure with screws.
4. Ensure top of cover fits correctly around grab handles.
5. Fit bar securing rear of squab cover to seat frame.
6. Fit hog rings securing rear of squab cover to seat frame.
7. Pull cover down tight and align hog ring location points.
8. Fit third row of hog rings.
9. Pull cover down tight and feed hooks though foam.
10. Connect hooks to rear of squab frame.
11. Align stowage pocket elastic to seat frame and secure with trim clips.
12. Pull cover down tight and align hog ring location points.
13. Fit second row of hog rings.
14. Pull cover down tight and align hog ring location points.
15. Fit first row of hog rings.
16. Pull cover down tight and connect hooks to squab frame.
17. Feed front of cover through to rear.
18. Secure bottom of cover to frame with clip.
19. Fit clips securing ends of cover to frame.
20. Fit headrest to seat.
21. Turn seat upside down.
22. Secure rear edge of squab cover to frame with clip.
23. Turn seat correct way up.
24. Fit inner edge trim casing to seat frame.
25. Fit outer edge trim casing and secure with screws.
26. Position arm rest to seat, secure with screw and loosen arm rest adjuster to the required position.
27. Fit front seat.