Seal - Crankshaft - Rear - Automatic Models

Seal - Crankshaft - Rear - Automatic Models

Service Repair No - 12.21.20.01

Disassembly

1. Remove CKP sensor.





2. Remove 4 bolts securing drive plate clamp ring and remove ring.
3. Remove drive plate from hub.
4. Remove 6 Allen screws securing hub, remove hub and collect spacer.





5. Carefully remove oil seal from cylinder block to avoid damage to seal location or running surface on crankshaft.

Reassembly

1. Ensure both seal location and running surface on crankshaft are clean.





2. Fit seal guide LRT-12-095 to crankshaft.
3. Fit new seal squarely onto crankshaft and remove guide.

CAUTION: Oil seal must be fitted dry.

4. Fit seal into location using tools LRT-12-091 and LRT-99-003.
5. Clean hub and mating face, spacer and clamp ring.
6. Clean drive plate and ensure free from cracks and distortion.
7. Fit spacer and hub to crankshaft, tighten Allen screws to 78 Nm (58 ft. lbs.).
8. Fit drive plate and clamp ring, tighten bolts to 45 Nm (35 ft. lbs.).
9. Fit CKP sensor.