Fluid Level Check - ACE System

Fluid Level Check - ACE System

Service Repair No - 60

Introduction

CAUTION: The ACE hydraulic system is extremely sensitive to the ingress of dirt or debris. The smallest amount could render the system unserviceable. It is imperative that the following precautions are taken.
^ ACE components are thoroughly cleaned externally before work commences;
^ all opened pipe and module ports are capped immediately;
^ all fluid is stored in and administered through clean containers.

Check

1. Clean reservoir around fluid level marks.
2. Visually check fluid level through side of reservoir. Fluid level must be between upper and lower fluid level marks.

Top-up

1. Clean reservoir around filler cap.
2. Remove filler cap from reservoir and fill to upper fluid level mark with recommended fluid.
3. Fit filler cap to reservoir
4. Start and run engine for 2 minutes to circulate fluid.
5. If necessary, top-up reservoir to upper fluid level mark.